Rear Wheel Well Closeouts Finished, Washer Fluid Hose Installed
With the side louvers in I was able to finally install the last closeout panels into the rear wheel wells. Kind of tough to get these fit properly, but once in they fit pretty well and create a good seal with the body.
I got my hands on a Corvette washer fluid spray nozzle finally so I was able to connect the washer fluid hose to that and clip it to the wiper arm. The hose is tucked into the wiper arm and zip tied at the base to keep it from pulling out when the wiper arm travels. The hose is then routed through a hole drilled in the body beneath the wiper so it is nearly invisible. I used some adhesive-backed loom clips to secure the hose under the body cowl.
