The GTM Supercar Build Log

O2 Sensors, Battery Stuff, Rear Window Prep

Tonight I installed the O2 sensors into the headers (the short O2 sensors are used pre-cat). When the cats are installed the rear O2 sensor ports will be plugged.

I then moved onto the battery. The tie-down is pretty straight forward to install – 2 J-hooks holding the tie-down clamp piece in place. I then drilled out a hole in the passenger side steering rack mount to connect the battery ground strap to. The powdercoat was Dremel’d off for an optimal connection.

Finally, I put the bulb seal on the rear window. This was harder than the other stuff done tonight.

Leave a Reply

You must be logged in to post a comment.