The GTM Supercar Build Log

Front Steering Rods Cut, Spindle bearings installed

As I mentioned previously, the steering rods needed to be cut so that the spindle bearings could be lined up properly with the front suspension knuckles. An inch was trimmed off each side (little more on the driver side) to get them to line up decently РI might have to trim off more later for a better alignment, as the rods do not have much adjustment right now. With the rods cut the tie rod sleeves were reinstalled and the spindle bearings with the bump steer washers were installed into the knuckles.

After that, I mounted the brake line brackets that go on the rear upper control arms of the front suspension. I did not do this yesterday because I simply could not find the brackets.

One Response to “Front Steering Rods Cut, Spindle bearings installed”

  1. pics of the bump steer kit? - FFCars.com : Factory Five Racing Discussion Forum Says:

    [...] [...]

Leave a Reply

You must be logged in to post a comment.